Home   |   About Us   |   Products   |   Services   |   Technology   |   Site Map   |   Contact Us
Bearing Housings
STAMPED HOUSINGS
    flanges   FLANGES
    pillow block set   PILLOW BLOCK SETS
    pillow block stands   PILLOW BLOCK STANDS
    flush mounts   FLUSH MOUNTS
    take-up units   TAKE-UP UNITS
    custom bearings   PARTS MADE TO YOUR PRINTS
    BRONZE BUSHED BEARING ASSEMBLIES
    pillow blocks   PILLOW BLOCKS
    flange side mounts   FLANGE SIDE MOUNTS
    flange mounted   FLANGE MOUNTED
    NEW PRODUCTS
    plastic bearings   PLASTIC BEARINGS
    SPECIAL PRODUCTS
    rubber boots   RUBBER BOOTS
    bronze bushed bearings   BRONZE BUSHINGS &
BRONZE THRUST WASHERS
    bronze bar stock   BRONZE BAR STOCK
         

Two-Bolt Flange Side Mounts
Complete, Inexpensive, Self-Aligning Porous Bronze Sleeve-type

Flange Side Mounts
  • EASY INSTALLTION - Just bolt them down
  • ALL UNITS SELF-ALIGNING - Speeds production, cuts costs, improves performance.
  • EXTRA HEAVY GUAGE STEEL USED IN ALL TOP AND BOTTOM FLANGES - Takes heavy thrust and shock
  • QUIET IN OPERATION - Rubber mounting grommet sets available at a slight extra cost.   Two grommet sets required per unit.
  • LOW IN COST
  • IMMEDIATE SHIPMENT FROM STOCK - Your order (large or small) will be shipped immediately
  • RUST RESITANT FINISH - Zinc plating on steel parts is attractive and rust resistant.
          Stock Shaft Sizes: ½", 5/8", ¾", 13/16" , 7/8",   15/16" , 1", and 1-1/16"
Steel Flange Side Mounts
P.O. Box 10526 • White Bear Lake, MN 55110-0526 • Tel: 651-429-4285 • 1- 800-894-1509 • Fax: 651-429-5765 • Email: info@manitoumfg.com